APC PDRPPNX10-M Specifiche Scaricare il pdf (Pagina 28)

24 InfraStruXure System - Installation and Start-Up

Connect User Input Contacts and Relay

Outputs to the User Connection Plate

Overview

Make contact closure connections (NO or NC) at

the user connection plate to monitor dry contacts.

You can make up to four input contacts and four

relay output connections.

The figure at the right shows the location of the

user connection plate on the roof of the PDU

enclosure.

Make the connections from inside the enclosure,

or remove the user connection plate and make the

connections.

Remove the plate using a Phillips or

standard screw driver to loosen the two

captive screws. Use the knockout in the

plate to route cables to and from the user

connections on the plate. If you remove the

plate, make sure that you do not disturb the

existing connections.

See the Operation Manual for

information on how to configure the input contacts and relay outputs.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Nessun commento

APC PDRPPNX10-M Specifiche Pagina 28