APC NetBotz 200 Guida Utente Scaricare il pdf (Pagina 10)

USER’S GUIDE

NetBotz Rack Monitor 200

Initial setup

You must define the following three TCP/IP settings for the Main Module before it can

operate on the network:

• IP address of the Main Module

• Subnet mask

• IP address of the default gateway

Access priority for logging on

Only one user at a time can log on to the Main Module to use its interface. The priority

for access, beginning with the highest priority, is as follows:

• Local access to the control console from a computer with a direct serial connection to

the Main Module.

• Telnet or Secure SHell (SSH) access to the control console from a remote computer.

• Web access, either directly or through the InfraStruXure

Central or InfraStruXure

Manager.

Do not use the loopback address (127.0.0.1) as the default gateway address

for the Main Module. Doing so disables the Main Module. You must then log

on using a serial connection and reset TCP/IP settings to their defaults.

To configure the TCP/IP settings, see the NetBotz Rack Monitor 200

Installation and Quick Configuration Manual, provided in printed form and in

PDF form on the NetBotz Rack Monitor 200 Utility CD.

For detailed information on how to use a DHCP server to configure the TCP/

IP settings at the Main Module, see TCP/IP and Communication Settings.

See SNMP for information about how SNMP access to the Main

Module is controlled.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 124 125

Nessun commento

APC NetBotz 200 Guida Utente Pagina 10