APC NetBotz 200 Guida Utente Scaricare il pdf (Pagina 40)

USER’S GUIDE

NetBotz Rack Monitor 200

To view details for a module: Click the module name to view all devices connected

to the module, the module model and serial numbers, and the module hardware and

firmware versions.

To change a module name or location: Click the module name. The system

automatically detects all modules and displays them in the Web interface with default

names shown in the table below. Change the Name and Location, then click Apply.

To blink the identifier number LED on an Expansion Module: Click the module

name. Set the length of time for which you want the LED to blink. Select the Blink

Identifier # checkbox and then click Apply.

To configure a device connected to the module: Click the module name. Then

click the sensor or output to configure. Another page appears where you can configure

the device. For further assistance go to Temperature & Humidity page, Dry Contact

Inputs page, Beacon page, Relay Output page, or Switched Outlet page.

Any temperature and humidity sensors connected to an A-Link port will be

displayed in the TH Sensors table for the Main Module details, even if they

are connected to an A-Link port of an Expansion Module.

Type of module Default Name

Main Module MM

Expansion

Module

Exp XX (where XX= Identifier #)

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 124 125

Nessun commento

APC NetBotz 200 Guida Utente Pagina 40