APC NetBotz 200 Guida Utente Scaricare il pdf (Pagina 48)

USER’S GUIDE

NetBotz Rack Monitor 200

Outputs Tab

Beacon page

Use the beacon page to manage a beacon, if installed. When the beacon is on, the

Alarm Status will be Abnormal State and the State will be On.

To turn off the beacon: Select Turn Beacon Off, then click Apply.

To change the Name or Location information for the beacon: Click the

appropriate field, make changes, then click Apply.

To test the beacon: Select Turn Beacon On. Then click Apply. To stop the beacon,

select Turn Beacon Off. Then click Apply.

To map alarm conditions to activate the beacon: You can configure your system

so that the beacon turns on when an alarm condition occurs for one, many, or all

temperature and humidity sensors connected to the system.

1. In the section Mapping: Alarm Reaction, select types of alarms that will

activate the beacon.

2. If, for a particular alarm, you do not want all applicable sensors to activate the

beacon, click the alarm. Deselect sensors as desired, and then click Apply.

3. Click Apply again.

You cannot select or deselect specific sensors connected to Expansion

Modules. Under Expansion Modules, select the Any sensor checkbox so

that all sensors connected to all Expansion Modules will activate the beacon

for the alarm. Deselect the Any sensor checkbox so that no sensors

connected to Expansion Modules will activate the beacon for the alarm.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 124 125

Nessun commento

APC NetBotz 200 Guida Utente Pagina 48