APC NetBotz 200 Guida Utente Scaricare il pdf (Pagina 46)

USER’S GUIDE

NetBotz Rack Monitor 200

Dry Contact Inputs page

Use the Dry Contact Inputs page to configure and to view the current status and state

for all dry contact sensors, including APC door contact sensors connected to your

system.

To configure a sensor: Click the name of the sensor to modify. Change settings, then

click Apply.

To configure all sensors or a defined group: Follow this procedure to mass

configure all sensors or a defined group of sensors. When mass configuring Name and

Location fields, you can use wildcards so the system creates unique names and

locations based on automatically detected data about the module to which the sensor

is connected.

1. Use filter settings to display the group of sensors to mass configure. (For

information on setting filters, see Tables.)

2. Click Mass Configuration. Make selections, then click Next.

Setting Description

Normal State Set this contact to either normally open or normally closed.

Severity Informational, Warning (device status requires attention), or Critical

(device status requires immediate attention).

Selecting the Informational severity setting causes all devices to

display a status of Normal, even if devices are in an alarm state

Alarm Generation Enable or disable this sensor’s ability to send alarms.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 124 125

Nessun commento

APC NetBotz 200 Guida Utente Pagina 46