APC NetBotz 200 Guida Utente Scaricare il pdf (Pagina 42)

USER’S GUIDE

NetBotz Rack Monitor 200

Sensors Tab

Temperature & Humidity page

Use the Temperature & Humidity page to view current readings for all temperature

and humidity sensors connected to the system and to configure sensors.

To change readings to Celsius or to Fahrenheit: Click the thermometer icon in the

upper right corner of the table.

To change a sensor’s name or location: Click the sensor name. Change the Name

and Location, then click Apply.

The system assigns any detected sensors a default name. For any remote sensors

connected to A-Link ports, the default name includes Rem. For sensors connected to

universal sensor ports, the default name includes the module to which the sensor is

connected and the universal sensor port number. For example, Sensor Exp03:4 is a

sensor connected to universal sensor port 4 of Expansion Module 3.

To enable or disable alarm generation: Click the sensor name. Select or deselect

the Enable checkbox, then click Apply.

When alarm generation is enabled for a sensor, the sensor reports an alarm for a

threshold violation and the alarm is recorded in the event log. When alarm generation

is disabled, the sensor continues to monitor the temperature of the surrounding air, but

does not generate an alarm if the temperature violates a threshold setting.

To permanently change the temperature units, see Changing the default

temperature scale.

You perform the following tasks by first clicking the sensor name from the

Temperature & Humidity page to display sensor details. Note that you can

also display sensor details and perform the tasks in this section by clicking a

sensor name anywhere in the Web interface when it is shown underlined.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 124 125

Nessun commento

APC NetBotz 200 Guida Utente Pagina 42