APC NetBotz 200 Guida Utente Scaricare il pdf (Pagina 41)

USER’S GUIDE

NetBotz Rack Monitor 200

Alarm Status page

Use the Alarm Status page to view all active alarms for temperature and humidity

sensors, dry contact sensors, a beacon, the relay output, and the switched outlet.

For each category, an icon reports the status:

• The Normal icon if no alarms exist.

• One or both of the other icons (Critical and Warning) if any alarms exist, and after

each icon, the number of active alarms of that severity.

If communication is lost to a device or if a temperature sensor’s rate-of-change is

exceeded, in addition to an alarm, a Reset Alarms link will appear.

To clear a device disconnected (lost comm) or rate-of-change alarm: Click the

Reset Alarms link if, for example, you intentionally disconnected a sensor or you want

to acknowledge a rate of change. The Administration tab’s General page appears

where you can reset the alarm.

For additional details on how to clear the alarm, see How to Reboot, Reset

Settings, and Clear Alarms (Administration>General>Reset/Reboot).

If you have a Sensor Disconnected alarm and did not intentionally disconnect

a sensor, see Device Disconnected (or Lost Comm) Alarms for

troubleshooting details.

Normally, the top half of this page includes five regions titled Temperature &

Humidity Sensors, Dry Contact Input Sensors, Beacon, Relay Output, and

Switched Outlet. However, if a hardware alarm occurs for a module or if an

A-Link Power Overload Alarm occurs, another region will appear displaying

the alarm details.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 124 125

Nessun commento

APC NetBotz 200 Guida Utente Pagina 41