APC NetBotz 200 Guida Utente Scaricare il pdf (Pagina 21)

USER’S GUIDE

NetBotz Rack Monitor 200

Device Manager menus

Use the Device Manager menu to select the components to manage. For example:

1- T/H Sensors

2- Input Sensors

3- Outputs

4- Module Identification

Use the T/H Sensors option to view the temperature, humidity (if applicable), and

alarm status recorded by each temperature and humidity sensor connected to the

system. This option also allows users to configure temperature thresholds and rate-of-

change settings, enable or disable alarm generation, and reset rate-of-change alarms.

Use the Input Sensors option to view the name, status, location, and identification

information for each dry contact sensor connected to the system and to configure dry

contact sensors.

Use the Outputs option to view information about the beacon, the switched outlet, or

the relay output. Configure the identification information and normal state of the output

devices, map alarms that will activate the output device, and manually change the state

of the device.

Use the Module Identification option to view the model number, serial number, and

hardware version of each Main Module or Expansion Module, and the version of

firmware it is running. Configure the name and location of the device and, for an

Expansion Module, cause the identification LED to blink.

See Dry Contact Inputs page for information about configuration

settings.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 124 125

Nessun commento

APC NetBotz 200 Guida Utente Pagina 21